Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WS-C3750X-48T-L switch running C3750E-IPBASEK9-M Version 12.2(58)SE2 and I can't configure private-vlans because the private-vlan command isn't there. I can't find any documentation that says this is a licensed feature or that its not includ...
Hello, I am trying to use outside source NAT to modify a source IP address based on destination port for a downstream load balancer and can’t seem to get it to work. I would like to have my load balancer see the following, and my ftp source to be un...
Hello,I am using an ACE 4710 load balancer to balance generic TCP traffic between two servers using source IP address. I find that I now have a situation where I have different connections (TCP ports 20073, 20071 and 20025) coming in from the same s...
Hello, I have a requirement to load balance between real servers on different subnets, but I need to preserve the original source IP address through the ACE. I know the ACE can do Asymmetric server normalization but that appears to require the serv...
Hello.I’m trying to remediate a vulnerability scan that was run against our ACE XML Gateway running version 6.1. The scan came back with three possible vulnerabilities all referring to various versions of OpenSSH. How do I confirm what OpenSSH versio...
That didn’t work but I may see the problem. The switch license Level is LANbase despite the IOS.Does the LANbase license really prevent the use of private vlans?Cisco IOS Software, C3750E Software (C3750E-IPBASEK9-M), Version 12.2(58)SE2, RELEASE SOF...
Hello SachinWe ended up using the ACE in transparent mode, putting all servers on the same subnet behind the ACE and using the ACE as their gateway.We configured the second NIC on the servers for administrative access on a different subnet.Thank you ...
Thank you very much for your reply Sachin, however my question wasn’t so much about session stickyness as how to make sure the rserver sees the original source IP address (no nat), when the load balancer is not on the same subnet as the rserver.The l...
