Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Is it possible to set a preferred path for a route on 2 neighbors connected on the same vlan using OSPF point to point? Since the outgoing interface is the same for both peers I am unable to manipulate the path selection via cost. I have t...
Hi
We are currently facing a problem with our attendant console running version 11 connecting to CUCM version 11. Every time a call comes in MOH plays which is expected but after a few seconds there is always a 10 second pause of total dead air befo...
Hi All,
I came upon this feature and would like to use it on our CUBE. We currently have 2 SIP providers connected to a single CUBE and a PBX on the other side. I would like to know if I can use this feature to create an outbound dial peer for outgo...
Hi All,
We currently have a requirement to upgrade CUCM ver8.5 CUPS ver8.6 CUBACver8.6 and Unity connection to the latest version I have read most of the documentations available and I have a concern about the migration. The mentioned cisco applicat...
I got it to work by doing your suggestion thank you very much for you time Julio much appreciated
R1
router ospf 1network 0.0.0.0 255.255.255.255 area 0default-information originate always
R2
router ospf 1network 0.0.0.0 255.255.255.255 area 0defa...
Hi Julio
I tried this but it appears that it is still load balancing. Is there anything I missed?
Here is my config of Orbit as per your suggestion
router ospf 1 router-id 100.64.13.25 log-adjacency-changes area 0.0.0.10 authentication message-di...
Hi Julio,
Can you clarify where I should apply the routemap on the context of my diagram? Based on my screenshot the default gateway is being advertised FW which is the top most router that has an OSPF adjacency with QS and VC which in turn peers wi...
The router called Orbit is learning the default route from QS and VC neighbors and is currently load balancing the path. My requirement is to select QS as the preferred path and VC as the secondary. I hope that makes sense.
