Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We have enabled sssl vpn (webvpn) on our Cisco ASA firewall and applied a public certificate to the device.
Webvpn perse is working however since this is a publicly accessible portal, we are required to secure access using certificates.
Th...
Hi,
I'm building a design for a LAN and was thinking of using nexus 93xx as my core switch (x2) and 3850s as my access switches. I'd like to ask on the nexus switch how or what do you configure on to have HA on vlan interfaces (svi).
From the data...
Hi All,
I'm currently testing on ssl vpn using anyconnect client.
The requirements are
1. AD Authentication - Done and working
2. Specific group of users using AD security groups will be allowed to connect to ssl vpn - Authentication is working h...
Hi,I am currently load balancing between two paths to my remote site. However, one path has a 300ms rtt and the other is 250ms rtt. I would of course prefer the later. Without messing with the OSPF Cost, is it possible to prefer the second path? Than...
Hi Joel!
Thank you so much..I will try this out but hope you don't mind some questions
I understand this section
"map-value memberOf "CN=GRP-anyconnect,OU=Security Groups,OU=Groups,DC=test,DC=com"policy_anyconnect"
it will call group policy "policy...
Hi Rick,I would prefer not to load balance because access in terms of speed, to a remote application will vary. Prioritize the 250ms path and the 300ms path would be a backup link would be the goal. Yes, i was hoping there is another way than modifyi...
Thanks Juan! I'm not sure of the actual impact if i modify the area os the links Could you expound on the other option "route maps and adjusting metrics being sent to the remote router." Here's a simple diagram for your reference.
