Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our customer believes the only way to verify data is being encrypted properly is to tap the fiber connections between our routers (encryptors). They are afraid that data might traverse the network that hasnt been encrypted.I contend that using cisco ...
I believe that a native vlan does not need to be configured (name, ip address) with anything specific as do other non-native vlans. For example in my brief config below, only vlan 16 is configured with non-default values while the native vlan 500 has...
I have a router with the following key chain configuration:key chain <KEYCHAIN1>key 1key-string <EIGRP_KEY1>accept-lifetime 00:00:00 Oct 1 2010 infinitesend-lifetime 00:00:00 Oct 1 2010 infiniteIt is connected to a switch with the following key chain...
I have an IE3000 switch and during bootup, it failes to find an IOS so the bootloader prompt appears. a "dir flash:" shows that there is no flash: filesystem. I am having difficulty creating a flash filesystem from bootloader commands.Can anyone prov...
We have a Cisco Access Control Server (TACACS+ version 5.1) with an additional 2 port NIC card. This produces 4 ports on the ACS server(G0 through G3).After initial setup of the ACS server with an IP address on G0, I connected a Windows 7server with ...
Glen.Grant, I disagree with you that the native vlan specifially needs to be defined in the configuration file. This is my main point which has been tested in my lab. I am just looking for the specific documentation that states this is correct. Thank...
JosephDoherty, This is exactly my point about not needing to define the native vlan as an interface in my L3 switch but where exactly do I find the documentation to support your point (and mine)? Thanks.
Thanks for the response. Our NTP server is providing the current time and date. So if I understand your response correctly, we should be alright since the date is past Oct1 2010. On a side note, is there a reason why the key chain start dates would b...
I did NOT do the 'acs reset-config'. Will try it now.Also it appears from Cisco documentation that G1, G2, and G3 are "blocked" ports.http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_hw_ins.html...
So it looks like you have two options:1) Look at resolving your 6500 port-security issue. (Do you have access to configure the 6500 port-security?)2) Troubleshoot the G2 interface configuration. If you cannot see the web interface with the Win 7 ...
