Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,i just configured my srst to support sip phones. During fallback all phones (sccp and sip) are able to register to the srst router. First i try sip to sip are working, then sip to sccp are also working, but when i tried sccp to sip i get ...
I'm trying to set up auto attendant which will allow caller to dial a local number. see config belowCall Manager 9.1DN: 1700Forward all calls to VoicemailUnity Connection 9.1System Call Handler>Auto atttendant>1700System Call Handler>Auto atttendant>...
i'm trying to setup a C3925 and trying to configure fax .but later found it no longer support " fax protocol cisco" as shown on the help commad. is there a no way to enable this or i'm just missing something? we are going to migrate our voice gateway...
I have setup two spa8800 on the two different site. I can successfully make and recieve call to/from both site. But I cant find a way to automatically use the next available line when making an outbound call. On both spa8800 a USERID was define on ea...
Just fixed the problem. it seems that there is missing config on my call-manager fallback. also during srst mode, i was not able to calls between sccp. I just add "appliation default".@rr,i could not get the logs, sccp phones will disconnect upon iss...
Hi Rob,set up a phone 7102-FAC_PT with Internal_CSS and call was sucessful. No other similar entry on system starting 1???.i have set up a auto attendant>caller input 1, which point to conversation/Caller System Transfer but i get in error " you cann...
Thomaswhere you able to solved this?.. in my case i takes about 3-5 mins for the phone to register (phone service: connected) although i was able to see the dialpad on the phone. After the phone register, i could only make the phone ring but could n...
