Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've read the other posts regarding terminal servers and they've helped me move along but I can't quite get past this one hiccup. When I try to connect to the one switch I'm testing with it appears to connect but then I never get the prompt> for bei...
Hello and thank you in advance for any feedback.I have a 2621 Router in one of my departments located in remote campus building. The primary link is a laser link that goes down when we have a decent amount of fog. We have a T1 backup, ISDN (which I...
My apologies for not starting a new thread but so much of this thread could apply to my version of the question.
What if you had a certain block of numbers being used by your CER for the ERL masking and you only wanted to allow inbound calls from t...
The new switches don't have an aux port they have a 10/100/1000 Mgmt port (4500 and 3850). I will try the connection to one of the router's aux port but the puzzling part of what i'm seeing on the switches is that it accepts the username/password an...
I have a similar issue with the utility for a 4500 going from 2.0 to 2.3.2. firewall is off, i can ssh to the unit, pinging it is fine. keep getting the unreachable message from the utility.
I've always used YAST from the command line then setup NTP under the Network Services option on the left menu. Works for VSMS as well. Just type 'yast' at the command prompt after you SSH/telnet to the box.Hope it helps.Matt
