Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The customer does not have reported the Private Phrase Password during on the CCM installation.There is any way to do a password recovery ???Kind regards,Marc
Hi,the customer has 2 hosts with same IP network and want to move one to another CPD but don't want to change IP addresses. The connection between both hosts will be with a Serial Wan. Don't have MPLS Knowledge.The connection will be:HostA---Router--...
Today, in a customer site I found a funny issue.If I press the mode button while 5 secons, the configuration is reset and the switch restarts.See the log below.Do you know if this is known issue ???MASTER_HSRP#00:04:15: %EXPRESS_SETUP-6-CONFIG_IS_RES...
Hi,I want to trace a CSNA dial from the IBM Host to another llc station attached to a token ring interface.The session works when the PU is active through a cip router but when I use the spare cip router it doesn't work.Wich commands should I use to ...
Hi there,thank you very much for the info both of you provided.Knowing wich are the router models that can provide the L2 VPN servicea and that the customer cannot aford it, now we will implement a more simple solution with bridging as the scenario i...
Hi Vikas,thanks a lot for the information.We are planning to use Remote Office type routers, 1800, 2800, etc.But, the interfaces will not have IP Address ??? How I will manage the router ?I've been searching in the Cisco documentation, and didn't fin...
Hi Clarke,I found this document on the web, I supose it will be helpfull.http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c/fnsprt3/dcdvtyas.htmKind regards,Marc
