Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have two 2960X switches in a call center and two call recording servers connected to port 40 in both switches. (switch is not a stack).
They need to monitor voice vlan of both switches in to both recording servers.(SW1 & SW2 voice vlan t...
Hi Chris, we performed this change on the rmcm application user main page not from device association page. so there is no possibility to accidently click "Remove All Associated". any further help on this?
Hi,We also experienced this same issue in CUCM v11.0.Engineer performed the change to remove one user in the rmcm application user main page, but all devices from controlled devices also removes user from CTI controlled device profiles. We raised TAC...
Hi Julio,
I tried the same method, but there is an error when I try to use same destination port for 2 sessions. Cisco does not allow it. I can't think of other possible way.
