Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,i have a problem with a CUCM 6.1.5 Publisher . When i change some device entries , perhaps " Phone load name " on a Cisco 740 phone or the partion , i can't save the changes . If i push the save or reset button nothing appears. I check it wi...
Hello ,Caller ID name is sent by our telco ( IE Facility ) and we want to block this on the IP Phone. The Gateway is controlled by mgcp. All the checkboxes under "PRI Protocol Type Spezific Information " are unchecked . Se0/0/1:15 Q931: RX <- SETUP ...
Hi all ,Equipment : CUCM System version: 7.1.5.32900-2Hardware : Platform Type 7845H2 we have problems to upgrade the Phone 6941 Firmwareversion SCCP69xx.9-1-1-1-sr to SCCP69xx.9-2-2-6 . the following problems occur:The phone displays the new f...
Hello ,our problem was a result of a corrupt database. Please check the Log files in CUCM . have a look for "missed table entries "cliutils dbreplication repaircheck logs again the path to the log is displayed after the repair. hope it helps good...
Hello all , I test the upgrade in our lab with 2 Cisco 6941 Phones and a WAN Simulator . In this test it looks like we hinting the knowing bug. If we upgrade from Software 9-1-1-1 to 9-2-2-6-Sr1 and use the wan simulator settings ( delay 80 ms 2 Mbi...
