cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
894
Views
0
Helpful
1
Replies

How can i block the IE Facility Display Name on a mgcp gateway

hajo.pees
Level 1
Level 1

Hello ,

Caller ID name is sent by our telco ( IE Facility ) and we want to block this on the IP Phone. The Gateway is controlled by mgcp. 

All the checkboxes under "PRI Protocol Type Spezific Information " are unchecked .

Se0/0/1:15 Q931: RX <- SETUP pd = 8  callref = 0x7100

        Bearer Capability i = 0x9090A3

                Standard = CCITT

                Transfer Capability = 3.1kHz Audio

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0xA18382

                Preferred, Channel 2

        Display i = '123456  123456'           #   we want block this number

        Date/Time i = 0x0C061D0C2824

                Date (dd-mm-yr)   = 12-06-29

                Time (hr:mnt:sec) = 12:40:36

Thanks

1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

Under MGCP endpoint config you can choose to change or block calling/called name/number. Just adjust as you want those parameters.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: