Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We deployed click to call not to long ago and we are having trouble making it work correctly.All work "Ok." except that I cannot figure out how to build the dial plan so that local calls don't send the area code if it is in my outlook contacts. Long ...
Hello everyone.I am having an issue where my CUPC Client cannot connect to my deskphone. I have gone through user, and application setup and all looks fine. I get Not Connected - Invalid credentials.
I am trying to configure THO or LCR via Route Filters, Route Groups, Route Lists.Is there a max number of clauses per Route list?I am trying to create a route filter where Area Code == xxx and Office == xxxLooks like I can only add up to 20-21 clause...
Good afternoon everyone.I have a customer that runs a recording application that look at the SIP header to record calls. Here's the call flow:CallManager 4.1(3) SIP Trunk => Recorder.The recorder is expecting something like:INVITE sip:123@12.12.12.12...
I have been told that a Cisco 2821 voice enabled IOS can covert an incoming fax to a .tiff file that can then hand to exchange server or Unity server.Is that possible? Could you point me in the right direction?Thanks in advance.
Thank you tcatlinins. I have this document and I have followed. However, we do have problems because as you might guess the area code is on the outlook contact which is needed for smartphones to dial. I can setup a dial rule that identifies and strip...
Michael,Actually, it does work. Thank you so much. I went back and for some reason CUCM did not save my changes.Thanks for your help. I will rate your post.One last question, do you know why video is not available with desk phone? Should it be?
