Hi,I would expect this to work fine.Via the SM<slot>/0 interface you configure both the router-side IP address ("ip address ..." command) as well as the WAAS side IP address ("service-module ip address ...") and the WAAS side default gateway ("servic...
Hello,Yes, it is indeed required to connect the WAN-facing link to the WAN interface and the LAN-facing link to the LAN interface. Otherwise traffic optimization might not work correctly.Please also make sure to following the cabling guidelines docum...
Hi,Also see this guide for how to use the recovery CD or recovery USB key:http://www.cisco.com/c/en/us/td/docs/app_ntwk_services/waas/waas/v511/configuration/guide/cnfg/maint.html#wp1173532Regards,Michael
Hi Ronaldo,Not sure I understand your topology correctly, but if your two CPEs are just separate layer 2 path, you should look into configuring Standby interface on both CM and accelerators, see [1, 2].If, however, the two CPEs should be different la...