Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm trying to setup RMON on an ATM circuit to do the following:1) To alert the management system when the link utilization reaches 85%2) To alert the management system when the link utilization drops below the 85% markI would prefer to achieve this...
HiCan someone please confirm that it is not possible to configure 802.1q trunking on an ethernet interface. I'm busy with a lab setup and the router (a 3620) will not accept the encapsulation dot1q x (where x is the vlan number). I'm running IOS12.3 ...
I've configured a CSS for SSL termination. When testing the page on HTTPS I receive a certificate. I can see the initial three pages but when I try browse further I notice the lock on the Internet explorer disappears and only a few links are returned...
HiI have a requirement to locate servers on a number of switches. I've used a host finder utility to identify a load of servers but there are still several outstanding. As our environment is quite complex I'm not really wanting to resort to tracing c...
Hi I have a router (Rtr-A) connected to an ATM link. I also have the following connections to Rtr-A:Rtr-B (level-1 router) on S0/0.100Rtr-C (level-1 and 2 router) on S0/0.110The routes I'm summarizing are 196.5.128-131.0/24 into a single route of 196...
Hi.I believe Vivek is correct. I don't know exactly what you want to achieve but as far as I'm aware your options are as follows:1) Capture traffic as per Vivek's suggestion and filter within your analyser tool.2) Use the 6500s mini protocol analyzer...
Hi I've just upgraded to IP Plus version. The answer is yes, you can configure Dot1q using the encapsulation command under the subinterface using a normal ethernet interface as apposed to a fastethernet interface.Thanks to everyone for your help. EP
Hi SpremkumarCould you just confirm something for me please? Do you know if this command is supported on a normal ethernet interface as apposed to a fastethernet interface. Meanwhile I'll check the memory req.Another thing is.. I thought the MZ in th...
Thanks for the quick response. Please see the output below.Cisco Internetwork Operating System Software IOS (tm) 3600 Software (C3620-I-M), Version 12.2(31), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-...
