Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I have two ise does used for device administration, one is primary for both administration and monitoring and the other is secondary for both.
Since both ISE in across two Data centers i have configured Primary ISE as the first authentication ...
Hi,
I recently deployed this wireless solution for a customer with 3702AP and cisco 8500 series WLC running 8.1.102.0.
I noticed that some of the AP dont allow any 5GHz client to be connected on these APs. The Channels vary from (36,40,44,48) and (6...
Cisco Nexus 9k after a hardware reset, the reason code is unknown. I guess that only reset caused by software will have the reason on " show system reset-reason". Is my guess right ? thank youshabeer
Hi,I am facing issue with ASR redundancy. I have configured the redundancy mode as sso. However the relaod the show redundancy output states that the Operation mode is non-redundant and configured mode is SSO. Any idea on why this difference. Pls hel...
Hi Manannalage Rasika,
to upgrade the WLC i have to go through a few CM and approvals. Is there any bug or issue similar to this reported earlier ?
Thanks
Shabeer
Hi, What band do you see on the controller for the devices which has high latency?If it is on 2.4 try enabling band select on the WLC and see if it improves the latency as the clients will try to connect to the 5Ghz band if it supports. Thanks
Hi Karthic, Thank you so much for pointing that out.I was checking this line. My ignorance.cisco ASR1001 (1RU) processor with 1155937K/6147K bytes of memory.kudos to you
