Has anyone experienced issue with VLAN tagging and Hyper-V 2012.  Our server Team wants 1 management Vlan and one Migration VLAN.  Also, it is teamed nics on one Port channel so I create the portchannel to be a trunk and trunk the 2 vlans.  I can see one vlan associated to the Vnic but it is not routing even though it has a Ip addressed assign on correct VLAN.   One Ip is pinging on the other vlan.  This happens without no VLAN Native.  I have toyed with native VLANs. However, same thing occurs. interface port-channel90   switchport mode trunk   vpc 90   switchport trunk native vlan 2   switchport trunk allowed vlan 2,207   spanning-tree port type edge trunk 207 is a vlan for migration and is a OTV vlan between 2 data centers. 2 is a management vlan.  Anyone have any luck with Hyper V server 2012? ... View more

One side POS1/0/0 SECTION LOF = 0 LOS = 0 BIP(B1) = 0 LINE AIS = 0 RDI = 0 FEBE = 0 BIP(B2) = 0 PATH AIS = 1 RDI = 2 FEBE = 1119 BIP(B3) = 463 PLM = 4 UNEQ = 0 TIM = 0 TIU = 0 LOP = 0 NEWPTR = 0 PSE = 0 NSE = 0 Active Defects: None Active Alarms: None Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA Framing: SONET APS COAPS = 0 PSBF = 0 State: PSBF_state = False Rx(K1/K2): 00/00 Tx(K1/K2): 00/00 S1S0 = 00, C2 = 16 Remote aps status (none); Reflected local aps status (none) Other end POS1/0/0 SECTION LOF = 0 LOS = 0 BIP(B1) = 0 LINE AIS = 0 RDI = 0 FEBE = 0 BIP(B2) = 0 PATH AIS = 1 RDI = 1 FEBE = 419 BIP(B3) = 859 PLM = 3 UNEQ = 0 TIM = 0 TIU = 0 LOP = 0 NEWPTR = 0 PSE = 0 NSE = 0 Active Defects: None Active Alarms: None Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA Framing: SONET APS COAPS = 0 PSBF = 0 State: PSBF_state = False Rx(K1/K2): C0/15 Tx(K1/K2): 00/00 S1S0 = 00, C2 = 16 Remote aps status (none); Reflected local aps status (none) My question is the Kbytes what does that mean loss of signal on RX ? Rx(K1/K2): C0/15 Tx(K1/K2): 00/00 There is no Auto protection Switching on this circuit it is straight point to point. ... View more