Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can anyone please advise if the E5-2637D (v3) CPU is supported for use in a C240 M4S (assuming 2133MHz memory)?The datasheet for the C240 M4S doesn't list it, but does list the E5-2637E (v4), which requires 2400MHz memory to get the full bus speed...
Simple question right? I do SIST zoning every other day but when I was asked this by a colleague recently, I said it resolved to the port or the wwpn, he suggested I was wrong and then proceeded to show me Cisco docs resolving it to be everything fro...
I have two pairs of clustered FIs, each with identical C220 M4 servers patched into 2248 FEXs. Each server has two network adapters, a MLOM 1227 and a VIC 1225. Only port 1 on the MLOM is patched to Fab-A and only port 2 on the VIC is patched to Fab-...
I'm hoping this should be an easy one to solve.
I have a C220 M3S server giving me the "Local disk config destructive to current server" error when I try to associate an SP to it. I don't care about data loss, as the disks are new and the SD card ca...
I've just finished reading the Best Practices in Deploying Cisco Nexus 1000V Series Switches on Cisco UCS B and C Series Cisco UCS Manager Servers document. Near the end there is a section with VSM placement options.None of the options advise placing...
I consulted the Cisco Press for a definitive answer and found in the CCNA DC book on page 577, the "SCSI Controller" is classified as the initiator, which is consistent with the HBA. Thanks Francesco!
I appreciate your help Francesco, but you've really only echoed what I said. Specifically, which object is the initiator?a) The server consuming the storage.b) The HBA.c) The port on the HBA that is zone to the target.Thanks.
Hi Wes,
My use case is SvSAN on a S3260.
I have two SSD drives mirrored and split into two LUNs - 100GB=boot and 350GB=cache. ESXi 6.5 sees both of these perfectly.
I also have a 60TB RAID6 LUN created from 13+1 HDDs that looks OK in the Service Pr...
