Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI just want to make 100% sure that the supervisor 6 modules for the 4510R chassis must get installed in slots 1 and 2 to run them in full redundancy.Pictures confuse me. C
Hi AllI have three sites: Site A, which is the main site. The site B and C are in the same city, but different areas.B and C are each linked to A via 192K dedicated circuits, and linked to each other via a 512K dedicated circuit. This give us a triag...
Hi AllWe have two sites - each with its own PABX, and a 320KB direct line between them. This line is being used for data, but we want to route PABX voice traffic over it as well.This is where the problem comes in. I went to http://www.cisco.com/en/US...
Hi AllI have a Catalyst 2948G switch, which is unable to autosense on some its interfaces. If you look at the LEDs on the front panel, the ones that have nothing connected to their interfaces illuminates every 10 seconds or so.If I hardcode the switc...
Hi AllI've got a 3550-48 EMI switch (running IOS 12.1(20)EA2) that is running at 100% CPU utilization. The VUR_MGR is running at 98% - which is crazy!I have already upgraded all the 3550s on our network to version 12.2(25)SE - which is the latest ver...
Great that the reinstall worked! However, having to reinstall a brand new appliance out of the box is not acceptable at all. We took delivery of our DN2 appliance today, and guess what? Dead in the water. Now we have to wait for the appliance to be a...
Great, thanks Jon - I just wanted to be 100% sure before we release the final config for this switch. Nothing worse than having to spend two days going up a mountain to fix a config error!CheersCPS: Apologies for the typo in the subject line - it sho...
Thanks for the reply Chris.We have four voice channels available between the two PABX's (Siemens HiPath 300). Each of these channels is configured to use 17K of bandwidth. We had the channels down to 3 at one stage, and we even had the priority bandw...
Hi VincentThe config on both routers look like this (except for the IP addresses being different, of course). I have removed some of the more sensitive information, but take my word for it that connectivity is not an issue. We are using interface s0...
