Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am setting up a 9800 controller and I want to assign vlans dynamically using ISE. I have it set up and working, but I can only have 16 vlans in the list of vlans in the flex tag. If a vlan is not listed there, the wireless device joins the nati...
Hi, have set up ISE so it will dynamically assign vlans based on users and user group, but ran into a problem with devices that do not have 802.1x
Is there any way where users could log into their device portal and add their mac address and have th...
Hi, I am using ISE to assign VLAN dynamically based on user login.
I can get the IP part working, but i also need to have the multicast on that specific vlan working.
it seems like even though i am on the specified vlan, the multicast stays on whatev...
Hi, I have two C3750G switches that are doing the exact same thing. port 1-2, 5-6, 9,10 ports are not enabling when I connect to a remote switch using MM fiber SFP modules. If i plug the same modules into ports 1 and 2 with a fiber patch cable, then ...
Hi, I am running a 3750E-48PD switch with firmware 15.2.SE1 UniversalK9 firmware as a master and I want to stack to a 3750G-16TD currently running 12.2(35)SE5 IP-Base. When i try to stack them I get a "booting in mismatch mode" and then it hangs. I u...
Thanks for that info, I have a WLC on the site, but as i understand, in local mode. all the traffic is tunneled through the WLC.The wifi is high bandwidth usage.In local mode, is all traffic tunneled through the WLC? couldn't a few very high bandwidt...
The way this network is set up is they have about 20 groups that all want to have access to the computers, printers and speakers in their groups. All groups have their own vlans and only the devices in their group are on their vlan.The reason I want ...
