Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI migrated data from WCS 7.x to CPI 1.3.0.20All data (existing maps ...etc )was migrated succesfully but when i tried to make another maps i realized that all commands in section Monitor>Site Maps is not function properly (does not display anything...
Hi,I have one Catalyst 6509E chassis and two SUP720.The bootup sequence on SUP 720 (standby hot) failed .Messages that appear on SUP 720, on the console port indicate o software crash. How can i resolve this problem?I don't have a flash card in SUP...
Hi,I connected AP 1522 to AC power source and this is the message that i received on the console port.%CDP_PD-2-POWER_LOW: All radios disabled - AC_ADAPTOR (0000.0000.0000)Why this message apear ?This is not sufficient power to bring up radio interf...
Hi,I have a problem with CUCM-Subscriber vesion 7.1.2.30000-3.I found the screen of CUCM-Subscriber server stuck at this message " Mounting local filesystem OK" (see attachement).I reboot the system and the boot process remains stuck at the same p...
Hi,After a wireless network interruption, one of MAP 1522 it's not joining to WLC .What should I do to solve this problem?Thanks.(Cisco Controller) >show ap join stats detailed 00:08:30:bb:53:20Discovery phase statistics- Discovery requests receive...
MAP1522 was powered by 12VDC power source and worked well but few days ago something wrong is happened with the 12VDC power module on MAP 1522.Something is broken on the power module on the MAP1522 because the MAP1522 cannot power up with 12VDC powe...
I updated the firmware version but the system stuck in the same phase.You know if It's possible to solve this problem if I used the recovery disk ?Or the system need to be reinstalled.Thanks.
Thanks Gregory, I use MCS-7835-H2 with 2 HDD DG146BABCF model, firmware version HPD5 .Version 2.8.1 is the latest Cisco Firmware Update that I find on Cisco website.http://www.cisco.com/web/software/283046733/51628/FWUCD-2.8.1-H-README.pdfThis ...
Please clarify for me this aspect.How to make a major software upgrade from version 7.x to version 8.x ?It’s sufficient if I have on ESW contract for software licences?What is the procedure?Thanks.
