Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a HWIC-1CE1T1-PRI in a Cisco 2811 running IOS c2800nm-advipservicesk9-mz.124-18b.bin.When I enter the "card type E1 0 0" command (it is in WIC 0 slot) I get the following response:SYINDEV01RW02(config)#card type e1 1 0 ...
I am installing 3 times VWIC2-2MFT-T1/E1 in a 3825 to provide 6 E1 connections running ATM PVC's. I will have 2 times AIM ATM installed in the router as each AIM ATM will only support a maximum of 4 E1's. I need to split my E1 ATM links into 2 bundle...
Hi,I have a problem with my ATM/IMA subinterfaces in that I can't even ping my local interface from the router despite it showing UP UP.I am connecting to 3 times E1's using VWIC2 mutliflex cards on a 3825.I have an ATM aim model and all of the abov...
I have a problem on a 3825 router with 3 VWIC 2mf E1 i/f's, and an ATM aim module.My telco has supplied me with 3 by E1's configured as a 6Meg bundle. At the far end this then breaks out into a frame-relay network on which we intend to connect to mut...
I have a single remote device attached to a 1700 sereis router. I need to ensure that if anyone disconnects the device, they can't easily plug anything elses in to the router and hence wanted to use a mac-adddress access list. I have created an acces...
Thanks Giusppe,I am happy with the sub-interface and PVC configuration, it was the AIM ATM, and clocking setup I was not clear on, but I think you have sorted that out for me now.I will be setting this up mid-January when I go out to Mauritius. We wo...
Hi Giuseppe,thanks for the feedback. I have had a look at the links that you attached have produced a propsoed config which I have attached below. Please have a look and let me know if this looks OK?RegardsSteve
Also, one other test connection that exhibited same problem, suddenly started working about an 60 minutes later for no apparrent reason!!!Telco claims they did nothing
OK, but we did try a HWIC-1FE first with the same result.Also, forgot to add the remote router frame-relay i/f config, so here it is:Note s0.1 and s0.2 are on existing frame-relay network and work OK (have been in use for a number of years)s0.101 is ...
