Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the same problem as the following post:https://supportforums.cisco.com/thread/176673?tstart=0&viewcondensedAlso, LMS fails inventory collection every time. I click on the "failed" link from LMS Portal, but the page never comes up detailing wh...
I am logging to MARS from a Cisco ASA 5520 and read somewhere (can't remember where) that you can configure the ASA to include the domain name in the accessed URL (instead of just IP) of the log entries. This is the data I need logged to MARS. One ...
I recently performed a Compact Flash Memory upgrade on my 6509. Everything is functioning normally with the exception of SNMP. I am using MRTG to monitor the bandwidth on a few key interfaces. Since the upgrade (I upgraded the MSFC and Supervisor ...
Where do I find the ROMMON Software? I can't seem to find it in Software download section. It's for a 6509 w/Sup720 and MSFC3 card. I need c6ksup3-rm2.srec.8.4.2 specifically.Thanks in advanceChris
I've decided to leave WinRM service as manual. After reboot, LMS is fully functional and runs with no errors. If this service being set to manual causes me problems in the future, I will update this discussion. Thanks for your assistance.
One example is when trying to schedule a config sync, I get the following:DCMA0055: URN_NOT_FOUND : urn "JRM" : Not found !!DCMA0077: Could not create job. Check dcmaclient.log for more details.However, I delete the ctmreg files and restart services ...
