Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a very large network that I need to migrate from classic EIGRP AS mode to Named mode. The network consists of hundreds of edge routers and L3 switches configured in the same AS. I can't seem to find any information regarding migration of AS mo...
Is there a good configuration guide for deploying the S170 and CDA to provide Transparent redirection based on AD groups? I have a client that would like different web filtering groups for general users and management. I believe this is the direction...
I have some remote ASA5505's that I am going to need to format the flash and push new code to. I have about 60 sites to do, and no remote hands(no remote console either). So I grabbed a 5505 on my dest to test the upgrade procedure. I blasted in a co...
I'm looking at the WS-C2960S-48TD-L and have a question about the uplink ports. Is it possible to mix 10G on one uplink and 1G on the other? The datasheet says 2x10G SFP+, 2x1G SFP so I am thinking mixing is not possible. Just wanted to see if I cou...
Pair of 7K's running hsrp for L3 redundancy. I would like to add this vlan to a VPC from the two 7k's trunked up to a pair of 5010's. Attached to the two 5010's is another VPC to a 3560x with the L3 linknet on the port channel. I know I can't run a...
My current flash is corrupt due to this bug.CSCuc98398The solution for the bug is to copy running-config off of asa to tftp server, format flash, download the new image and the running-config just copied back to the freshly formatted flash, copy flas...
So I took one of the boot loop asa's, deleted the 8.4.6 version that was installed on it and manually pushed the same 8.4.6 code via scp (downloaded tonight from cisco). Rebooted and sure enough it worked. So I figured the code upload was corrupt. So...
Did you ever find a solution? I have several 5505's that are doing this. They seem to run 8.4.3 fine, but not 8.4.6 or 8.4.7. I have two boot commands in the config, the first for 8.4.6-5 and the second for 8.4.6. plugging in the asa, it tries to bo...
The 2960s uplink ports can either be 10 or 1 depending on what SFP you put in there... it's not a case of 'ordering' the switch with either/or. I'm asking can I put a SFP+ in one port and an SFP in the other. If the two uplinks are not married to th...
