Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I followed the below link and life is good on pulling info from the config via API. But how would I go about pulling info from the API that exist in show commands? IE get the output of show cdp n or show ip route etc?Getting Started with NETCONF/YANG...
If you import all your switches into Cisco prime can it report if the device is on smartnet or not? If it is on smartnet when it will expire etc? If not prime what Cisco software can do this?
The Sup 2T has 3 gig ports and 2 10 gig portsIf VSS is setup between 2 6500s with 2 Sup2Ts in each with VSL over 2 of the 8 10 gig links on the supervisors: Will all 12 of the 1 gig links be usable at the same time for uplinks to other devices? Can s...
Unfortunately same thing..3650>py nc-routing.pyFailed to get CDP: ncclient timed out while waiting for an rpc reply.Traceback (most recent call last): File "nc-routing.py", line 46, in <module> print('Failed to get CDP: {}'.format(e)) File "C:\P...
When i add timeout 300 it just hangs there for 300 seconds...Then says this...Failed to get CDP: ncclient timed out while waiting for an rpc reply.Then if i hit cntrl c it says this... <module> print('Failed to get CDP: {}'.format(e)) File "C:\Py...
Thanks for all the links I will have to read them in due time.How do I enable operational data?<IP-FORWAR-MIB xmlns="urn:ietf:params:xml:ns:yang:smiv2:IP-FORWARD-MIB"/>yields below.{ "data": { "@xmlns": "urn:ietf:params:xml:ns:netconf:base:...
