Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on my lab setup with CUCM 11.5, a 2811 router running IOS 12.4, and a Twilio SIP trunk. I can route a call to the trunk from an IP phone without an issue, but the call won't set up. I get the following dump from the Twilio debugger (reda...
I am working on my lab setup with CUCM 11.5, a 2811 router running IOS 12.4, and a Twilio SIP trunk. I can route a call to the trunk from an IP phone without an issue, but the call won't set up. I get the following dump from the Twilio debugger (reda...
I have a client that wishes to use IP Communicator and an IP Phone concurrently with a shared line appearance for an employee with a visual disability. The user would need to dial the phone with IPC and then pick up the handset of the IP phone to sp...
EUREKA! I figured it out! This after having issues assigning a public IP address to my 2811 on one Ethernet interface and having a private one on the other. I reverted back to my old 1:1 NAT configuration and just kept playing around trying to find a...
Good morning, Nathan! I made progress yesterday with inbound calls routing to my phone, although I have to state that neither Twilio or Cisco Support have been especially helpful in helping me achieve that result. The Twilio guy told me things I alre...
No luck, Nathan. I have the same problem with the allow list. I thought I wrote you back to let you know, but apparently was just thinking about doing so and never got around to it. Silly me! I shelved it for the weekend and figured I'd get back to i...
IOS 12.4 would not allow these commands, so I'm reverting to 15.1 to try again, Nathan. I had them there originally before downgrading the code, but was missing the trust list entry back to CUCM.
I'll keep you posted.
