Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Chaps, I have a Cisco 1841 and i am trying to configure it to create a new network for my esxi lab environment. my home network is 192.168.1.0/24Lab network is 192.168.100.0/24 My problem is that from the ESXi host which has 192.168.100.111 I can ...
Hi, I have an ASA 5505 at home... I have connected it to my Router/ Wi-fi ap and configured it to get DHCP IP and routes.. all works except pinging netbios names on my inside network... For example, on my outside network (connected to my router) I ...
Hi, I have tried to find a line between the recommended size for the small business line and the normal access switches line. I know that this may vary a lot, however, would it make sense to use Small business switches SF or SG series on a company wi...
Hi, I have a Home Virgin media cable connection at home. As far as I could understand so far, the only way to get this working with my Cisco gear is by putting the superhub on modem mode.On modem mode, it becomes just a dumb modem assigning and IP vi...
Hi,We need to have one connection with less internet bandwidth assigned to it than all other other connections. Basically it is a separate conection from all others, incomming just from one switch port and separate VLANI know this can be done on the ...
Hi, If I ping from my inside network:C:\Users\user>ping -a 192.168.1.101Pinging DISKSTATION [192.168.1.101] with 32 bytes of data:Reply from 192.168.1.101: bytes=32 time=1ms TTL=64Reply from 192.168.1.101: bytes=32 time=1ms TTL=64Reply from 192.168.1...
Hi Samuel, Many thanks for looking into this. I have tried the commands on my 3550 at home and it only worked for download, not upload. I think the 3550 is not fully compatible with this class mapping as I had to adapt the last command to service-po...
Hi,I have tried to implement policing to inbound traffic but it didnt work. Any suggestion for the appropriate commands to get this working?Many thanks
