Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,I have this case and I would be very thankful if someone has the answer for ! When Wired AutoConfig service is enabled on a Windows XP (or 7) station that is connected to an IP phone, the "Additional Information is needed to connect to this net...
Dears,I have this case where Cisco ISE server is used to authenticate & authorize clients on the network.I configured the switch port to authorize the client in case the ISE server is dead (or not reachable).The thing is that I want to reauthenticate...
Guys,I would greatly appreciate if someone can post the necessary configuration on the Cisco ASA in order to make this work because I am experiencing similar problems as Acruzgreg and group-url did not solve it yet.
Thank you Reza.However, I think this part of the document states features of the Catalyst 4500 series.I want to make sure this specific fiber module is Hot-Swappable.In other words, I need to know if there are any modules that are considered exceptio...
Hello Neno,I am using PEAP and below is the dot1x config under the switchport:interface GigabitEthernet0/4 switchport access vlan 107 switchport mode access switchport voice vlan 156 authentication event server dead action authorize vlan 107 authenti...
