Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am reading a Cisco Press book on Securing Perimiter Routers. "Cisco Router Firewall Security" R.Deal @2005It gives an example of Auto Secure with a couple of humongous ACL's. One for example is for all Private Ip Source Addresses RFC 1918 blocked f...
Maybe I should be calling support..but I dont' think this is a level 1 deal.Basically this is a cut and paste from 2 lab 2811's with advanced ip. I don't beleive I have a tunnel established here. Can anyone see anything inherently wrong. This is pret...
Can anyone please tell me if these cards are essentially interchangeable provide they are configured correcty. I asked for internal DSU wic cards, and recieved VWic T1 controllers. It looks as if when you config the time slots of the T1 Controller Ca...
problem: remote end of non failed side black holes out the bgp interface for almost a full minute waiting for big daddy to converge. (we've lowered timers bgp to 12 36) Question: If I had some new 2811's deployed that were OER capable would this not ...
We have a headquarters 4.5 multilink line going to an MPLS cloud supporting 14 remote sites. We have now unwisely aquired a "managed" VPN failover "solution" for 4 of these remote sites utilizing HSRP. The problem is the black holing caused by BGP la...
Yes a tunnel has been succesfully negotiated. I am not sure why this is but maybe it's supposed to work this way....but when I try pinging the remote ethernet interface...it can't succesfully process the reply that it gets saying that it's not an ip ...
i have done that thanks. I had the tunnel up briefly but I got lost in the weeds and rebooted...and it's gone. Thanks for your help...tomorrow's another day i guess and at least i'm not a contractor out in the feild with it....
Everyting is configured on the lan or ethernet interface with standby commands. The routers are considered to be in a standby group or groups depending on your needs. The unique standby ip address is the default gateway address advertised by all rout...
but the vwic will ultimately work for just data i am presuming then? I am concluding that we just paid a little more for it but I can go ahead without rma's etc.
So therefore if we were speaking of a potential injection of 10.130.0.0/12 address....that would be within the 10.128.0.0-10.143.255.255 range and 128 <=130<=144 ?? WE therefore should not permit that range of addresses to be injected if we already ...
