Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi friends,We are working on a case for 3 buildings in a campus having a total of approx 1500 AP's. Client is looking for RTLS and RFID based application support.We are proposing Mobility services engine for the above requirement. Need help on few qu...
Hi Team,We have a customer scenario wherein we are using UCS Chassis along with Fabric Interconnects in a virtualized environment using VMware. The applications deployed are contact center applications of Cisco, Aspect and NICE recording.Fabric Inter...
Hi Folks,One of my customer has ordered a CWLMS server for their DataCenter and they would be managing the entire network equipment from this CWLMS.Now the customer wants to keep a cold standby CWLMS sever at their Disaster Recovery site.Can the cust...
Hi,One of my client has recently purchased Cisco IDSM-2 for their core router i.e. 7609, however the client has missed purchasing the SUSA licencing for signature updates. Can the client still configure the IDSM-2 without Signatue updates( in any mod...
Thanks Robert.As per the cisco documentation, ERSPAN is not supported on 4500 with Sup7.Please suggest if you have deployed this solution.Regards,Manmeet
Thanks Stephen for your reply.However there are 2 issues:1) The source port is on a 4500 switch and not on UCS fabric interconnect.2) Destination port would be a Virtual port on one of the VMs installed in a blade of UCS.Something of the sort of RSPA...
Hi Masood,RJ 21 connectors are basically having 50 pins in a single connector, thus usually these connectors are used to connect Ethernet ports in bulk from a switch with RJ-21 ports to a CAT-5 or CAT-6 rated patch panel, or between two patch panels....
Hi Tauer,Your switch configuration seems to be fine, I think you need to check the scope configuration carried out at your DHCP server.Pls rate if helpful.
