Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear allI would like to ask if FEX N2K module are working with- non blocking mode or what called wire speed or not- local switching within module portsSent from Cisco Technical Support iPad App
Dear All,I have an issue with one of our switches, switch model WS-C2960-24TC-L, i am not able to display switch temperature as below, Switch#sh verCisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 15.0(2)SE2, RELEASE SOFTWARE (fc1)Tech...
Dear All,I have CUCM 7825-I4 with two NIC cards, How can i use both of these NICs for failover scenario like connecting each NIC to one core ? In that case does both NIC has same IP address ?What is redundancy mode they work with ? (Active/Passive or...
Dear All,i need to install CUCM 7 on VMWare workstation 9, for Lab purbose , please help me with PC requirements and any comments i should consider during instalation stepsThanks in Advance
Dear All,i faced an issue with my cisco 7604, that it doesn`t support per-packet load sharing, i have 4 connection that i need to load sharing between themdoes any one has an idea what is the best way to solve this issue
Dear Ronak,Really thanks for your helpmy last question, does this command has any impact on network performance during or after applying or does it has any recommendation ?again thanks for your great support
Dear Ronak, Thanks for your fast response, so i can connect each NIC to each Core and get better network connectivity with zero down time, as both NICs are working in Active/Passive mode, which NIC port is the active and which one is the passive an...
