The native vlan will be for untagged packets when trunking, you can use only one native vlan per interface but you can have different native vlan on different ports for the same switch.
There is a bug as well. %C870_FE-3-TXERR: error messages and reset of Fa interface on 877 routerCSCth20872 DescriptionSymptoms: The following error message is seen accompanied by a reset of the Fast Ethernet:%C870_FE-3-TXERR: FastEthernet0: Fatal tra...
Hi, The * will be always for the last hope, if the device is unreachable you will see the * as well. http://www.cisco.com/c/en/us/support/docs/ip/ip-routed-protocols/22826-traceroute.html Thanks!
Please send me the show module for the 4507, show int status, also, show interface gi 2/1 transceiver. Try using the command speed nonegotiate on both interfaces as well.Thanks!,
Oh Sorry, I did not notice you are connecting a 10GB interface to a 1 GB, it will not work, you can convert the 10 gi interface of the supervisor to a 1 gi port. " Supervisor Engine 7L-E has two modes (One-Gigabit and Ten-Gigabit), which can be ch...