Hi, I made a EtherChannel with a Cisco Catalyst 4500, using 2x10 Gbps Interface. but when I check Interface Port-Channel, I see it only show 10 Gbps!. I attach show version, module, etc.
Hi, I need to permit to user only create, delete or modify any access-list that begin with "TEST-". and another ACL that beging with any character the user is not allowed to modify. configure terminalip access-list extended TEST-ACL permit ip ... p...
Saludos a todos,alguien sabe como calcular el costo de un puerto por el metodo largo, segun este enlace menciona como hacerlo, pero he hecho las pruebas y no logro obtener los valores correspondientes.http://www.cisco.com/en/US/docs/switches/lan/cata...
Hello.I configured EIGRP between a Switch 3550 and an ASA-5505., The session of neighbors work without problems, but no EIGRP routes are exchanged.I try change the nameif and the security level but it still does not work ...**************************...
I have the ROUER C2811-NAT as follows:C2811-NAT:NAT for Network RED-LAN 192.168.8.0 / 24VPN Server for any.VPN Client connects to the LAN by VPN, and connect to internal computers (LAN) fine., In the NAT-R I have the following static route:ip route...
ok!; but the issue I have is when traffic between this Switch and the device in the another side is almost 12 Gbps, the traffic between them get only 5Gbps each interface..