Thanks for the reply; I understand the selection process for placing the route into the RIB; my ques...

When a new BGP peer comes up, what process (or in what order) are routes advertised to the peer? Doe...

Does anyone have a tried and true QoS configuration for a Nexus 7k?I'm trying to replicate the stand...

upstream peer upstream peer | |------------------------------------------- | | R1 (1.1.1.2) R2 (1.1....

Lei Tian,Thanks for the reply.The actual sequence of failure was the SPA card in the router R1, whic...

I have a situation where I'm trying to advertise only 4 host routes from a /24 network to my BGP nei...

Nothing official, but I have the following results myself for you to compare:64 byte - 7600Mbps 1131...

Is there any reason why you need to enable ip pim sparse-mode on a loopback address? even if you poi...

can you ping vrf mgmt lap.top.ip.addr?

Launching CiscoView from the main portal, if I use the device selector to select a device, I get the...

I have a situation where if I ssh into a box directly, I can paste a 250 line ACL without issue. If ...

I've had a customer mention this as well. From what I've gathered, it's a technology coming out in t...

Is there any rhyme or reason to how routes are listed with a simple 'show ip route'?I notice on the ...

I was wondering if there was a way to specify a wildcard in a Netconfig job...For example, here is a...

I have been doing VSS software upgrades using the modular IOS using the following process, and was w...