Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,How can I verify status of license (Ten Gigabit Interfaces) loaded on secondary (standby) pre 5 procesor on my ubr 10k platform?Command show licence display info about primary processor:Index 1 Feature: WAN_LicensePeriod left: Life timeLicense ...
Hello,
I have cisco 1921 platform with vpn configured. My certificate is going to expire in few weeks.
I need to send new crs request for renew certificate to my router. I have a few questions:
- do I need configure new keypair or can use keypair...
Hello,Is it possible to configure nat (cgn) on ASR 1k to permit the same private address always get the same port block allocation from the same public address? With that You dont need nat logging.regards
Hello,I have c240 ucs with raid 10 ( 6 disk) + one disk not configured. Is it possible configure that disk to automaticaly replace when disk in raid die? Something like hot standby.If there is no such a feature, what is procedure when one of disk s...
Hi,I have question about filtering bgp routes from bgp client.We are bgp transit for client.Client AS number for example 100Client IP 192.168.0.0/22We want only prefixes from AS 100 and be sure that there is no other prefixes than 192.168.0.0/22as-p...
Hello Xander,I would like to prepend only one local prefix and the rest prefixes advertise without prepending,Is the configuration below correct ? route-policy prepend-prefix-Xif destination in (x.x.x.x/20) then prepend as-path AS-NUMBER-YYYY 2else...
Hello,If it is possible to use ACL with IP to mirror traffic to/from specific IP addresses on L2 interface or Bundle-Ether (l2) e.g interface GigabitEthernet0/2/0/11.600 l2transportencapsulation dot1q 600rewrite ingress tag pop 1 symmetricmonitor ses...
Hello,What with modem working on 8 downstreams, should I apply cable monitor on Interface Cable ( logical mac domain interface) or should configure it on e.g every modular or intergrated interface ?I have e.g: interface Cable5/1/0downstream Modular-...
Thanks Marvin,
I still dont understand how trustpoint is connected with my ipsec site-to-site connection ( connection should work until I send crs request, and get new certificate back).
If I create second trustpoint 2 with the same keys to generate...
