Hi there, I installed the four acisim-3.2-1m_partX.OVA in ESXi, after that I received this message "Contact Cisco to supply response token for VM Activation challenge" and I need enter the activation token for continue with the installation (starting...
Hi everyone,I have a UCS-Blade and UCSM with version 2.1 (1e), I create the boot policy to boot from the disk local and raid 1.The trouble is that when the Blade server boot show me the screen in SHELL, in other words the server st...
hi everyone,I am new on telepresence, my client only purchase the MCU and two P42C40 and don't purchase the VCSc and VCSe, so the P42C40 are registered on CUCM version 8.6.2 as phone. So I create SIP Trunk on CUCM and route pattern for communication ...
Hi I am Jonathan Rivero and I am NEW on ASAs, I have ASA 5520 with Version 8.2(5), the ISP give me a block of IP pubic (201.148.156.193/28), one IP valid (201.148.156.194) have the Global NAT (all users LAN) and server FTP, but i n...
Hi everyone.I am new in ASA, I have the DMZ (10.1.1.0/24) configured on ASA 5520 and I achieve the reach Internet from DMZ (10.1.1.0/24), but now need reach DMZ from inside (172.16.12.0/24) and inside (172.16.12.0/24) from DMZ (10.1.1.0/24), in othe...
I try with the configuration default on port and wr, restart the switch and I configure the port again an save configuration, restart the switch. the trouble is solved.
Hi Marvin,Apologies for the delay but too much work here, I try with the next command.access-list DMZ_IN extended permit tcp 10.1.1.0 255.255.255.0 172.16.12.0 255.255.255.0access-list DMZ_IN extended permit udp 10.1.1.0 255.255.255.0 172.16.12.0 25...
hi Marvin.I try with ASDM but I do not like, I think that is better with CLI.I try with you tell me later, i think that this help me.access-list DMZ_IN permit 10.1.1.0 255.255.255.0 172.16.12.0 255.255.255.0access-list DMZ_IN permit 10.1.1.0 255.255...
