Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I am deploying a guest SSID at remote location in Felxconenct mode , and trying to do L3 webauthentication but clients are not redirecting to the splash web page. WLC is 3500 model with 8.5.131 software / AP model is 38021.While trying other auth...
Hi,
I have registered the license on new catalyst 9300 model using smart license manager portal. Now it is not possible to connect the switch again to internet or to use proxy methods to send license usage . I am not using any DNA product in my envir...
Hi all,
As i know, to configure HA for 5508 WLCs:
"It is mandatory to configure the IP addresses of the Redundancy Management Interface and the Management Interface in the same subnet on both the primary and secondary controllers."
i did that , but...
Hi,I have a situation where number of ie3000 switches are connected in ring topology and i want to add a spoke switch with a fiber link in trunk mode .lets say switch A has IEM-3000-8FM= module and one of the ports (lets say f2/1) on this module will...
Hi,I would like to know if i can replace traditional ring infrastructutre (IE3000 switch with fiber connection in ring topology) with cisco PON solution.My scenario is a MAN where broadcast traffic (comming from devices to ie3000 access switches) mus...
As mentioned in the document , you will have to connect to CSSM by configuring this URL on the switchhttps://tools.cisco.com/its/service/oddce/services/DDCEServiceYes, you can ping the domain to test conenctivityping tools.cisco.comPinging tools.cisc...
Hi,You just have to allow HTTP/HTTPS on the firewall for a L3 interface on the switch to be able to get internet access and communicate with cisco smart portal. You should also have an account on cisco smart portal, and switch license should be place...
Thanks Georg for quick response ! I would like to use IP SLA to track static routes (HA), from documentation I see that 2960XR supports only IP SLA responder mode. Is there any other way to achieve object tracking on 2960XR (15.2(4)E8) ? regards
Thanks Patoberli and Ravindran for reply !virtual interface address is 2.2.2.2 and I don't use ant ACL with Flexconenct.It works now , the problem was there was an old unmanaged AP (SOHO) broadcasting same SSID.
