Has anyone set this up successfully yet?   I have followed the brief config included in the doc starting on page 53, but I am not having much luck.   See attached Doc S4BFED.pdf for config that works.        

I have deleted a route pattern from publisher, but when using DNA it matches the deleted route pattern.Deleted 9.911 route pattern with partition X. When you run DNA for 9911 for correct CSS, it matches the deleted route pattern.I have reset gateway,...

Can the FE 0/0 (WAN)port be a source for spanning(mirroring)?I keep getting unrecognized commecnd output when trying to configure.Please advise.

We will be setting up a SR520 for a teleworker solution connecting back to UC540. Site where SR520 will be installed does not have a static IP. Will we be able to setup teleworker VPN with Dynamic DNS service on SR520?

I know it is probably not recommended or supported, but can a remote IP phone be setup using a Linksys router with VPN capability?