08-01-2011 08:13 AM - edited 03-07-2019 01:29 AM
Hi,
I cannot login to the wlan-ap0 wireless module in a 891 router
I did service-module wlan-ap0 session used Cisco as username and password
But it didnt work.
Reset the module using the method below and tried the login again but no luck
service-module wlan-ap0 reset default-config
service-module wlan-ap0 reset
Any idea why? How can we do a password recovery
Thanks
stan
08-05-2011 08:10 PM
There is no password recovery available on emebdded AP only a password reset. this is achieved by resetting Ap to factory default
Router# service-module wlan-ap0 reset default-config
- BUT before doign this, please try the below to see if you can login into AP
Router# service-module wlan-ap0 session
Username:
Enter Username and Password configured on router
If prompted again, enter Cisco/Cisco
NOTE: These steps need to be performed in above order.
Sudha Kulkarni
Wireless TAc
08-08-2011 07:26 AM
Hi,
I figured out the issue
It looks like when you do a "service-module wlan-ap0 session" we have to provide the username password that was configured on router.
Once you do that you can use Cisco Cisco to login to the wireless module
Thanks
01-13-2021 07:00 PM - edited 01-13-2021 07:01 PM
Try:
service-module wlan-ap0 session clear
You may still have the last session open.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: