Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I am trying to bringing up a Site-to-Site VPN tunnel between a ASA5505 and a Vshield Edge Gateway. It seems that Phase 1 gets ut, but not Phase 2. The logs says"Failure during phase 1 rekeying attempt due to collision""Received encrypted packet w...
Hi! I am trying to install Cisco ISE on VmWare Workstation 10. I have created the VM and when i try to boot the VM with the Cisco ISE .iso file in the drive, I only get the following error " The Cisco Identity Services Engine CD was not found." But i...
Hi! I have just installed a Virtual WLC at home for lab purpose. Now i want to connect one accesspoint to my wlc, but for now the WLC says "0 access points supported". Can i somehow still use the evaluation licens and connect a accesspoint to the wl...
Hi!Have anyone tried to run ASDM 6.1(5) and ASDM-IDM Launcher 1.5(50) on a windows server 2008 r2? Currently the computer is running windows XP and I want to upgrade to a server.. /Lajja
Hi!I'm about to upgrade my PI from 1.2 -> 2.0 Currently PI is running on a VM with Red Hat as the OS. I am thinking about migrating to a VM that runs Windows 2008 R2. Is this supported? The reason to do that is because the monitoring software that my...
Tuned the debugging up to 200 on both isakmp and ipsec, got following output, replaced public ip of remote site with 1.1.1.1 : Jun 13 07:54:19 [IKEv1]: IP = 1.1.1.1, IKE_DECODE RECEIVED Message (msgid=0) with payloads : HDR + SA (1) + VENDOR (13) + V...
Yes I have followed that guide. But when I boot the server, and choose installation type 1, ISE boots and shows med the error mentioned above. /Lajja1234
Hi!In ASDM you can use Packet Tracer to check where the packet gets stuck. I always use that feature to check any problems when I am not sure what to do. /Lajja1234
Hi!I have set up a similar solution for a customer. To get it to work I had to put the modem in Bridged mode, so the modem did nothing more than "forward" packets. That way the ASA got a public IP adress on the external interface and I only had to fo...
