Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, i have AIR-CT2504-50-K9 with installed 44 AP and working fine with 7.6.100.0 version. i have purchased 5 nos of L-LIC-CT2504-5A - 5AP Adder license for 2504 WLAN controller (e-delivery). while i am trying upload the license i am getting the err...
hi, i have configured vpn on asa 5505 and 881 router, as per below design,i am seeing the tunnel is built from cisco 881 router for few seconds and the its got delted. but nothing showing in asa. i have attached both asa and router configuration, ple...
i have 2 cisco 1522 series out door LAP connected to a 3560 POE switch which is not powering up, while ordering my dealer told that it will work with POE, and its go live stage, is there any way to upgrade switch with any IOS version where i can get ...
I have a senario where i have connected two location with a Wifi Bridge and a WAN link (256K), were currently they manually swap the connection in case of any WiFi bridge issue, my question is can i use and auto failover technics to avoid the manual ...
i have deployed wlc 5508 ( image 7.0.98.0 ) with 1262N AP and all 45 AP's are working fine,at the same site i had AP1242 which i have converted to LWAPP (8 of them), these accesspoint are registerd perfectly with 5508 but non of the radio's are up. i...
i will post the sh version, sh power inline and sh log later, i have refer the requirement for POE injector which is AIR-PWRINJ1500-2, can u tell me how these injectors are powered physically, is there any adaptor coming along with injector? as ther...
thankyou allafter connecting the Power Injector, these access point radios are enabled and up and running...but i am still not know,,these AP's are working with the same switch when it was in Autonomous mode...and why stop working when its converted ...
