Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with configuration of Cisco 876 router.I just cannot make him connect to remote site on BRI interface or via Dialer. Either interface reults with 'Encapsulation failed'. I have used standard configurations for this, as attached. Plea...
One of the data ports is flashing amber. The installation guide says "Port is blocked by STP and is sending or receiving packets"Can you exlain what this means, as it doesn't make sense for a blocked port to be receiving/sending packets.
Is the following supported on a 2620 router: NM-HDV-2E1-60. If not what 2600 family do support it. Does it also need a 2MFT-E1. What IOS does this require. I've searched cisco but it is not clear to me.
When trying to input 'dialer pool 1' as above, we get 'Highways(config-if)#dialer pool 1%Remove Legacy DDR Configuration first'which means removing the 'dialer map' statement.Please advise.
Thanks Leo.Have taken you advice and new config attached.We find now that he line doesn't come up at all. We tried ping telnet and snmp. Debug q.931 shows nothing. q.921 is fine.Any ideas ?Thanks, Kevin
MTBF info is shown for other products in the product guides for say a 2600.A search reveals this.So, I'm looking for same information for ASA; if it is there for other platforms, it must be availabe for others like the ASA ??
