Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,on a ASA firewall we neet to create a Lan to Lan IPSec tunnel to a remote peer.This peer is a simple third party modem using a DDNS service, having it a dinamic IP address.ASA, instead, hold a static public IP. Using ASA's VPN wizard or cli, we ca...
Hi, we've a Cisco ASAv licensed in Permanent License Reservation mode. We can't use standard Smart License or Satellite communications way. Basic license was inserted into Smart Account and it was installed correctly, using License Reservation wizard...
Hi,We've installed a virtualized FMC 6.3.0.This VM is on lab environment just for test, without any device managed, Internet access or any license added. Now, 6.3.0.2-67 patch, Snort Rule update and Vulnerability And Fingerprint Database have been up...
Hi,
we're planning to upgrade our UCM 11.0.1 to last 11.5.x.
With actual version we've also some 7940 and 60 that works properly (actual firmware was 8.1.sr2).
We know that UCM version 11.5 remove compatibility with some phone models, but not to 79...
Hi,
we're looking info about to configure a cluster of FTD 2140 in Active/Active with some firewall context enabled.
Obviously this all through FMC vm.
Which are best practices to do?
Thansk!
Hi,
in my case, after upgraded device to 1.0.03.27, issue persist.
All configuration was present but router doesn't authenticate remote vpn user, also after a complete user account remove/reinsert test.
I've done a complete factory reset and reload...
Hi,
just for my additional clarification.
I mean,
if suggested (and recommended), we can integrate TMS with AD, sure.
But actual UCM cluster infrastructure, where TMS must be configured, haven't any Ldap link.
It works with local phone user.
...
