Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi we are trying to swap out an old 887VA-K9 with a new 897VA-K9 and having some issues.We have used the same or essentially the same config on both. The 887 works and our OPNSense FW/Router can login via a PPPoE connection and is assigned our Public...
Hi we bought a bunch of Meraki MR33-HW AP's and I wondered if there was some kind of trial period to see if these are what we are looking for when setting up a community wifi project. The specs look good and we wanted to install 'enterprise grade' A...
I cannot get Caller ID working. That last PSTN caller is not shown on the spa3102 web/admin/voice/advanced page internally the last pstn called number is shown. The last previous firmware was 3.3.6 currently the spa3102 has Product Information Pr...
Hello,I am struggling to get this working afetr spending many hours looking at it I am now completely stuck. We are upgradng from a 857W to this 887 VA-M I have some experience of IOS and the 800 series. Our 857W works perfectly using almost the same...
Hi,I am an IOS beginner so please be gentle.I need to replace an ADSL modem and have a spare 857W. Can I use this to act as a simple bridge between the ADSL PPPoA connection and the FW WAN port?So: [ CISCO 857W ] ISP - PPPoA - BRID...
Re: Trial period for new Meraki UserHi thank you for your prompt responses. Yes we managed to get 1 device connected by claiming it.It now shows up under our Organisation - Wireless - Access Points. IT appears to be working and allows clients to conn...
Hi thank you for your prompt responses. Yes we managed to get 1 device connected by claiming it.It now shows up under our Organisation - Wireless - Access Points. IT appears to be working and allows clients to connect and browse the internet.We are n...
HI thank you for the fast response. We got these as used items essentially donated for the cost of the shipping. They were all ex corporate devices and 'unclaimed' whatever that means. I am not sure what organisation they historically belonged to. I ...
Dan,Yes ID is working on the line. I downgraded the firmware and then re-upgraded to the latest and CID is now working fine. No idea what the issue was with the latest firmware. It seemed to upgrade perfectly the first time and all options seemed to ...
Dan thanks for the reply. I just found this article http://en.wikipedia.org/wiki/FSK_standards_for_use_in_Caller_ID_and_remote_metering that confirms v.23 I have tried that but does not work. I posted in the other places because a lot of replies in r...
