Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am reading a CCDA book 3rd edition, in chapter 2 heading "network availability" has a sub heading named "workstation-to-router redundancy" (in page 52). That subheading listed "ARP" as one of the possible ways to realize redundancy.
My understa...
HiI'm trying to test multiple SSIDs in the lab and I'm battling to get only one SSID up and running, I have attached the configuration and the url that I read to configure the router but for some reason I'm winning. Please assist with viewing my conf...
Hi AllI would like to know what would happen to traffic exceeding supported maximum encrypted traffic?With the current ASR1001 2.5G ESP module, Cisco supports upto 1Gbps of IPSec encrypted traffic. - My question is what would happen to excess tra...
HiI have a problem with adding a Cisco switch to the NMS (Smarts). When I start a discovery process from the snmp manager (Smarts NMS) it does resolve the ip address into the hostname but once the discovery process is completed the device in question...
HiI have configured E1 to use PVDm to terminate ISDN connection but I keep on getting the above error message, can you please view my config and see if you can't spot a mistake.Layer 1 and 2 seem to be working fine but layer connection isn't working....
Hi I have tried to use different IP addresses and the behaviour is still the same, though I knew that changing an ip address won't help but I tried because I ran out of ideas.I also reset both the snmp agent and manager, and other types of switches t...
