Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Friends here is scenario,Suppose I have connectivity between CE and PE through a Gig Circuit like belowCE-------------------------------------------PE And bgp is configured on both ends but there is also a secondary CE and that is connected to other ...
Hi Team,I have an issue, I have checked the router and found all L2 ports are down but vlan 1 is up...I dont know why it is happening..please have a look in below config output::Interface IP-Address OK? Method Status ProtocolFastEthernet0 unassigned ...
Hi Frnds,I am seeking a help to design a network. Pls help the contents are below--I have following devices---two ASA-5540two fortinet 311Btwo cisco 3560 switches and a few L2 switches and routerswe've a server farm all in one vlan2 ISPs need to be k...
Best way to achieve this, use "rate-limit" to limit the traffic upto specified bandwidth.Please check below link that might help you to find your commands--http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfcar_ps1835_TSD_Products_Co...
Hi Vijaya,I would suggest you to check the clocking with ISP, if clocking is being provided by the ISP then what is that and configure it accordingly or if clocking is managed by you then internal keyword should work with line on other side.At the sa...
Islam, is right..the key commands to enable GUI access of router are below as mentioned by Islam...ip http serverip http secure-serverip http authentication localip http timeout-policy idle 60 life 86400 requests 1000You suppose to use first two comm...
Dear Kuldeep,As per my knowledge with the communication that I had earlier with Reliance is....If you are buying an ISP link of 1Meg then 1:1 means 1Meg of download and 1 Meg of upload, and In you scenario..if you will buy a 3 Meg link..then 1:4 mean...
