Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Wondering if anybody can help me with this one. We have a CUCM 8.5 installation that we have just provisioned a new 9971 phone onto. All is working fine, but the new 9971 keeps bringing up an XML Idle Application Error when it has been idle for an...
Hi all,Anybody know the command on the 1941 to look at the dsl stats for the ehwic interfaces? On the 1841, show dsl int ATM 0/0/0 and 0/1/0 did the trick, these commands are not available on the 1941.Any pointers would be much appreciated.Sent from ...
Hi, Wondering if anyone out there may have an answer to my issue with one of my customers ADSL 2+ / 1841 problem.I'm in the UK, and have a customer who has an 1841 with a HWIC1 ADSL. He has just upgraded from ADSL to ADSL 2+. I have an ADSL teste...
Hi, new on here, so please take it easy on me..I am looking for some ideas regarding a config I have been having issues with today.A site that i am responsible for has the following equipment installed:2 x 3750G Switches configured as a stack using S...
Hi all, I am having difficulty finding the commands to enable me to resequence an access-list on an ASA 5550. My access list now looks like this:access-list Outside_access_in line 1 extended permit udp *********access-list Outside_access_in line ...
Hi George,Many thanks for your reply. When we look at the configuration of this phone in CUCM, there is no URL in the Idle URL field. It seems strange that even though we are not calling an Idle URL, the phone is bringing up this error when it has be...
Hi Ste,I can see your ip nat inside on VLAN 1, but can't see your ip nat outside. Try putting it on Ethernet0.101Other than that I can't see what's up.CheersMarkSent from Cisco Technical Support iPhone App
Hi Jeroen,I'm hoping you get some resolution to this soon, I'm hoping the 887VA isn't eol, as I've been selling these like no tomorrow, but till now haven't come across the issue you're having. I've probably sold and installed 15 of these in the last...
Hi,What is happening here is that PC0 is sending it's ping into its connected switch on VLAN 1, as the link between the switches at this end is also on VLAN 1, this will traverse the link and end up on VLAN 2 at the other end.As you have configured b...
Hi,As far as I know, all SFP modules are LC connectors, you could get SC to LC patchleads if you change.CheersMarkSent from Cisco Technical Support iPhone App
