I cannot see the memeory of VIP4-80, but the VIP is working normally:Router#show diag 0Slot 0:Physical slot 0, ~physical slot 0xF, logical slot 0, CBus 0Microcode Status 0x4Master Enable, LED, WCS LoadedBoard is analyzed Pending I/O Status: NoneEEPRO...
On 3550, an interface is err-disabled, and must use shutdown/no shutdown command to reenable the interface, is there any method to let the switch reenable interfaces in err-disable state automatically
a 4515 sup on 4507R, whose two up link port is connected using trunk, and these two interfaces is up, but when another 4515 is inserted, the uplink 2 is down, while the second 4515 is removed, the uplink 2 on first 4515 is up again, why?
I use a PVDM-12 in 1760, and it works, but I don't know if I can use it without problem in any case: Packet Voice DSP Module Slot 0: Hardware Revision : 3.2 Part Number : 73-3691-02 Board Revision : A0 Deviation Number ...
I use show test command, does that mean that 4013 need two power supplies?Console> (enable) show testEnvironmental Status (. = Pass, F = Fail, U = Unknown, N = Not Present)**** WARNING WARNING WARNING ****This system has an insufficient number of pow...
