Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,I have an interesting situation that I can't find a Cisco supported configuration for. My customer has a pair of 5520's setup in a failover pair and has two internet connections. The primary ISP has an Adtran router onsite, but the back...
Hello,CUCM 8.5.12921 ISRI have a location with an h323 gateway connected to a fractional PRI and two FXO ports. This is a new install and I have the PRI working fine, however I'm not sure how to configure the analog overflow. From what I understand i...
Hello all,CallManager 8.5.1Gateways are both MGCP and h323What I'm trying to do is pass correct caller id to specific remote destinations, but the main number to all other off-net calls.So I have a remote destination with the number 915555555555 whic...
Hi Everyone,I have a site just outside Paris France that needs to replace their old PBX. Our corporate standard is CUCM so instead of upgrading their Alcatel to a newer model I would install a 3925 ISR in Paris and use the CallManager cluser in our L...
