Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I have the below tunnel configuration over a physical links of BW 155Mbps, however and while trying to utilize the full BW of the link we could not exceed 55Mpbs by any mean!! HYG the configuration sample along with the topology.@r1:=====in...
Hello All We are facing a problem with ur IronPort since ysterday that there is no outgoing mails pass through the Ironport and the incoming mails as well we are recieving the below two messages An application fault occurred: ('egg/omh.py get_concur...
Dears,Kindly note that i have a problem with the backup of our CUCM, our CUCM Version is 8.6.2.23900-10 and actually this probelm appeared after a minor upgrade from 8.6(2a)SU2 to 8.6(2a)SU3.The backup always fails at TFTP component, log file attache...
Good Morning Dears,Kindly note that i've a two Cisco catalyst 6513-E stacked togther over VSS. Sups are "Cat 6500 Sup 2T with 2 x 10GbE and 3 x 1GbE with MSFC5 PFC4". IOS is "s2t54 Software (s2t54-ADVENTERPRISEK9-M), Version 15.1(1)SY, RELEASE SOFTWA...
Dearsi have a problem with FXO Port installed in H323 gateway. the problem is when the incoming call reaches to the FXO port, connection plar command configured to deliver the call to a specific extenion but the problem is the caller hearing the ring...
Sorry for the missing info, but could you please list for me what are the info you need. Anyway, both my routers terminating the tunnel is "Cisco CISCO3945-CHASSIS (revision 1.0) with C3900-SPE150/K9 with 987136K/61440K bytes of memory" and IOS is "V...
