Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a ASA 5540+SSM-40 on which I have configured webvpn and it's listening for connections on the outside interface.It can be accessed from outside the network (the internet) and works just fine. The problem is, I want to access it from insi...
Hi,I'm trying to make an "old" network redundant. Up untill now it was star shaped, each edge router only had one link to the core and we used static routing.But now it's going to look mostly like in the attached drawings and I wish to implement OSPF...
Hello,I have a bunch of "DS-SFP-FCGE-SW" SFPs left over from a SAN switch.I was wondering, could I use these for gigabit ethernet connectivity between other cisco devices?In the documentation it says that these support 1/2Gbps fiber channel and also ...
Hello,I have a bunch of Linksys SIP phones and a c2811 acting as a CME. It has a VIC2-4FXO card in which I have extension 131 coming from a PBX (on voice-port 0/0/0)My SIP phones have 4 digit extensions, and I used the command "connection plar xxxx" ...
Hello,I'm a total n00b at ASA so please give me a hand I have a ASA 5540-AIP40-K9 ....so it has the standard built-in 4 GE ports + a SSM-40 module.So I basicaly just got it out of the box, updated the software and made some minor config changes.I con...
Well gentlemen I think I got to the bottom of it.First of all the configs i was using were something like this:ACL: ip access-list extended ANY permit ip any anyip access-list extended NAT-BUILDING1 permit ip 10.20.0.0 0.0.255.255 anyip access-list...
Hi,I already tried changing the sdm template a few times (rebooted each time)3560X#sh sdm prefer The current template is "desktop routing" template. The selected template optimizes the resources in the switch to support this level of features for 8 ...
Well guys, I've already established based on documentation and cisco Feature Navigator that PBR >> should << be supported. I'm trying to find out why it doesn't actually work.I'm running the latest IOS for the 3560-X c3560e-universalk9-mz.150-2.SE2I ...
Hi,I'm having the exact same issue.I have a 3560-X with ipservices license. I had the sdm template set to dual-IPv4-IPv6-routing which acording to cisco documentation should support PBR for IPv4.....the ip policy route-map NAME does not show up in t...
