Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,we try to access a firepower 1010 (remote office) from our headquater over an ipsec tunnel via ssh.Therefore we configured a loopback interface, which is part of the routing over the vpn, and this loopback is pingeable.Somehow we are not a...
Hey guys,I just compared different firepower models 1000 series vs 3000 and I wonder why the 2000 series is missing on the webpage?https://www.cisco.com/site/us/en/products/security/firewalls/index.html
Is the 2000 series soon EOL/EOS ?
Thanks for yo...
Hello guys,we configured
BDI interfaces
on our ASR 903 and using a
Tengig interface
for bridge domains....We wonder which speed the
BDI interfaces
use?Bandwith parameter shows
1000000 Kbit/sec
. but this I think is important for overlaying protocols ...
Hey guys,we have one customer with an active VTPv3 domain...Two C4500x cores as "primary" and some access switches as "clients".I need to add a new vlan and receive: Root(config)#vlan 21VTP VLAN configuration not allowed when device is not the primar...
Hi all,I have a voice gateway and some phones connected to the same switch. The problem is: The voice gateway doesn't tag his packets for QoS, the phones do it automatically.Switch-HW: C3750-24TS-S1UVersion: IPBASEK9_12.2(55)SE4Qos is enabled and rew...
#sh int TenGigabitEthernet0/0/0TenGigabitEthernet0/0/0 is up, line protocol is upHardware is A900-IMA2Z, address is acf5.e628.2d00 (bia acf5.e628.2d00)Description: connect wan nekwn1wansw01 1/4MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,reliabi...
Hi BB,yes I'm on the VTP Server and I just need to know if I need to do it in a maintenance window in case the command "vtp primary vlan" will force network interrupts??My tasks would be:1. Make the "vtp server" to primary vtp server -> "vtp primary ...
